READYPCB board solder points connections no need jumper wires
READYPCB board solder points connections no need jumper wires
READYPCB board solder points connections no need jumper wires
Ready for use
I eliminate the traditional jumper cables, or aerial connections to avoid annoying noises or parasitic signals, as well as disconnections due to movement of these cables, which are the big problem with breadboard or breadboard modules.
Quality
RPCB1 is manufactured in 1 ounce with gold layer and TG180 which resists higher temperatures and allows soldering and de-soldering to carry out other projects and longer life of the PCB card.
The background or solder mask is white to better appreciate the welds or dirt on both TOP and BOTTOM sides.
Warranty
The Trademark registration and Patent for this product are just being processed, so if you see a copy of my design, I think it will be well received so that our clients finally have something new that allows them to improve their final projects.
This RPCB1 model is the first of several designs that I will be presenting this year 2024, and allows you to join rows and columns with a welding point between them according to the attached jpg.
The third layer or GND is to isolate zones GND-A, … GND-1 ..to..GND-14, …GND-D, being in total 18 independent zones of GND, which can be joined with a simple point of soldering to the BLUE GND line this is done through the TOP layer. (This allows, for example; to isolate analog signal areas from digital signals on the same PCB card).
also…
We can join any of the 80 columns to either negative, positive or ground with a solder point. It could also be joined to EARTH by welding the point through the BOT layer.
EARTH is the fourth general layer and acts as a general faraday layer and is accessible by BOTTOM, soldering it to the GND BOTTOM point.
Terminals 100 thousands of an inch pitch separation, can be soldered on all sides of the RPCB1 board. In the corners we can join multiple RPCB1 cards using a general EARTH.
The holes for bolting the plate are isolated from EARTH, but can be joined with a spot weld by TOP or BOTTOM.
Additionally, the K,L,M,N,O,P,Q,R,S,T rows can be joined independently of each other with smaller welding points, which requires more welding experience and use of a microscope if possible.
All plates are new and recently manufactured, and include their dehumidifier and protective plastic.
Sectors 4 layers
Top and bottom layers
Top and bottom layers all complete PCB
readypcb.com
